Search Results for 27-pin

21-33384-51 (PIN) 21-33385-51 (SOCKET) Contact, Pin and Socket, Quadrax, Type M38999 Series I & III Special, Size 8 ... Website: www.amphenol­aerospace.com 21-33384-51 (PIN) 21-33385-51 (SOCKET) I H REAR INSULATOR FRONT INSULATOR REAR INSULATOR SLOTS INNER CONTACTS FRONT INSULATOR KEYWAY OUTER CONTACT

Search Results for ms3112e10-6s end of life Amphenol - Sine Systems and Industrial @ Amphenol ... SMA PCB End Launch Jack 50 Ohm High Frequency 0.010 Pin 901-10511-3 N-Type Straight Plug to N-Type Straight Plug 0.085 Hand Formable 50 Ohm 6 inches 175101-R1-06.00 SMP Right Angle Plug to SMP Straight Plug 0.047 Hand Formable 50 Ohm 300 mm 095-725 ...

Buy 10ft Amphenol CS-DSLSZH25MM-010 Cables Direct from the Factory at Cables on Demand. Amphenol 25-pin (DB25) Low Smoke Zero Halogen D-Sub cables protect your personnel and equipment from the harmful environmental effects of wire combustion, such as toxic and corrosive PVC based fumes. Double shielded LSZH cable design features 24 AWG data-grade wire, pre-terminated to DB25 male and female d ...

Loose pin header packaged by tube or tape and reel: Per pin price. Less than half of standard : Marketing price. Assembly process: High speed sticking machine(900cycle/minute) Normal speed insertion(60cycle/minute) Positions. No limited: Maximum position within 100. Application: Flexible to cut for any position. Change over for different ...

The series is available in single axis and triaxial versions with a 10 ft (3 m) integral cable or a multi-pin, threaded, electrical connector for easy installation and setup. ... Sensitivity: (±3%)27.5 mV/(m/s²) Measurement Range: ±10 g pk; Measurement Range: ±98.1 m/s² pk; Broadband Resolution: (0.5 to 100 Hz)0.3 mg rms;

Pin moisture meter-selection and use 4 4.1a Using auxiliary deep wall moisture probes in measure mode 5 4.1b Detecting hygroscopic salts 6 ... 9.2b Moisture Measurement 27 9.3 Physical Specifications 27 9.3a Power 27 9.3b Size (W x H x D) 27 9.3c Gross weight 27 9.3d Maximum needle depth 27 ...

contact pin can be soldered or use 4-way indent tool #47025 6. shows cable entry dimensions. recommended cable stripping dimensions 6 6 6 bullet contact ferrule 5/8-24unef-2a iterface per mil-std-348 series: n jack customer outline drawing ... amphenol rf created date: 9/27/2024 1:41:17 pm ...

37-Pin D-Sub Cables (DB37) -- 37-Pin D-Sub cable assemblies by Amphenol provide the perfect I/O solution for your DB37 d-sub equipped devices. All of our 37-pin d sub cables come fully populated with 24K Gold plated contacts, molded DB37 connectors, and offer varying degrees of shielding depending upon your specific requirements.

Shock test 100 g (single shock) / IEC standard 60068-2-27 Vibration test 15 g / 10…2000 Hz IEC standard 60068-2-6 (resonance frequencies excluded) EMC test Electromagnetic emission according to EN 55011, cl. B:2009 + A1:2010 ... Pin 1 +24 VDC (−15 / +20 %) Pin 2Output 1

STEP 3. Insert inner conductor into the CONTACT PIN, crimp it with the crimp tool as shown. Then slide the FERRULE onto cable. STEP 4. Insert the MAIN BODY into braid and dielectric. STEP 5. Slide the FERRULE over braid, crimp it with the crimp tool as shown. MHD,CAI.f 11/27/01 5:45 PM Page 195

Available Inventory: 27. 7016-0133. 2.4mm Cable Assemblies 7016-0133. Add to compare list Datasheet. Part # 7016-0121 2.4mm Male to 2.4mm Male 12" Strain Relief Cable Assembly for .047 Cable Available Inventory: 150. 7016-0121. 2.4mm Cable Assemblies 7016-0121. Add to compare list Datasheet.

Amphenol’s B07 vertical broadband pedestal provides an environmental protective housing for passive or active coax or fiber networks. The B07 has a 14”x20” internal usable area and sits between the B06 and CMPH- 75 series pedestals in terms of size.

Size (Height x Length x Width) .4 in x .4 in x .4 in 10.2 mm x 10.2 mm x 10.2 mm Weight .15 oz 4.2 gm [1] Electrical Connector 1/4-28 4-Pin 1/4-28 4-Pin Electrical Connection Position Side Side Mounting Stud Stud Mounting Thread 10-32 Female 10-32 Female [2] All specifications are at room temperature unless otherwise specified.

27 pin receptacle, square flange, non-water tight, crimp contact, nut, without contact, x/y/z/w insert position asgl2a2827pclcx. 27 pin wall mount receptacle,circular flange, non-water tight, crimp contact asgpp316sar. plug, ground power connector for rail vehicles maintenance, 4pcs power contact + 6pcs signal contact ...

3-Pin XLR: Mounting Thread (Grid) 0.25 - 60 UNS: 0.25 - 60 UNS: Size - Diameter: 0.79 in: 20.1 mm: Size - Height (with grid) ... temperature unless otherwise specified. Accessories. Supplied: 079A49: Phantom powered microphone holder 20mm dia with 5/8-27: 1: 64443-01: 1: 64444-01: 1: ACS-42: Calibration of a Series 377 (Type 1) microphone ...

Q pn p pi pi p ng n n n ing ning n pin niin Eeme pin niin n n pp i n n Sh niin in g hi p Ipn p ih ni REV241122A(CL) CONNECTING PEOPLE + TECHNOLOGY www.amphenol-antennas.com 1 of 7 Hexa band antenna, dual polarisation, 36 connectors ... Front-to-Back Ratio, Total Power, ±30° dB > 26.5 > 29.7 > 29.2 > 27.9

STEP 3. Insert inner conductor into the CONTACT PIN and solder on the cable. Then slide the FERRULE onto cable. STEP 4. Insert the MAIN BODY into braid and dielectric. STEP 5. Slide the FERRULE over braid, crimp it with the crimp tool as shown. MHD,CAI.f 11/27/01 5:45 PM Page 196

Hz, 4-pin conn Installation and Operating Manual For assistance with the operation of this product, contact the PCB Piezotronics, Inc. Toll-free: 716-684-0001 ... TI ROV EØ 1 .0 [27 94 ]W HA 3 8 FN SB UL 1 MODEL 080A68 MOUNTING BASE MODEL 081B05 MOUNTING STUD.800 [20.32] CUBE GROUND Z-AXIS Y-AXIS X-AXIS 1.23 [5.8].40 [10.2]

pin contact size 22d m39029/58-360 sealing plug 10-405996-222 at a, c, e, g, j, l, n and r locations 8 places see lq-21818-18 for arrangement pin contact octonet 21-032906-001 or equiv. 4 places pin contact size 22d 10-497620-215 6 places see l-21809-35 for arrangement pin contact size 22d 10-497620-215 at d, h, m, s, t and u locations 6 places ...

Ouverture de clé (hex.) 27 (28) Monter le capteur de position (Anneau ou aimant en U) concentriquement - Pression superficielle de l'aimant : 40 N/mm2 max. - Couple de serrage vis M4 : 1 Nm max. - Veuillez utiliser des entretoises Tige à l'épreuve de la ... Pin Câble Signal