Search Results for nsa8420-9

BPF 112-136 is an LC band-pass filter. Allows the whole 112 – 136 MHz band to pass. Good out of band rejection. Can be used as a preselector to protect a receiver against interferences from transmitters normally being outside the band-pass range.

We would like to show you a description here but the site won’t allow us.

s 7431 t contact@amphenol-socapex.fr W www.amphenol-socapex.com s s on notes USB3CF TV CapLock & PlugLock Discover a selection of products compatible with your USB3CF TV Memory Key :

2-Point Mounting and Downtilt Bracket Kit 36210006 50-115 mm 2.0-4.5 in 4.1 kg 9.0 lbs Bottom View REV012516O www.amphenol-antennas.com 2 of 5 696-900 MHz / 696-900 MHz Location of the MDCU or MDDU for RET Control Tilt indicators covered by transparent caps. Manual adjustment is accessed by removing the caps.

Search Results for fs1-r38-20a2-10 40.9 A3 - RELEASE NEW DWG FORMAT 11DEC13 DRP - Amphenol Sine Amphenol Sine Systems 44724 Morley Drive, Clinton Township, MI 48036 USA www.amphenol-sine.com 10-2023 Machined Contacts, Sockets & Pins Part Number DescriptionSize AWG Type AT60-215-1631 Male Contact - Pin, Gold-plated 1614 Machined AT62-209-1631

We would like to show you a description here but the site won’t allow us.

The DT800 utilizes Airmar’s proven Tilted Element and broadband technologies in this depth and temperature Smart™ Sensor. The DT800 is a low-profile, retractable, thru-hull sensor that accurately computes depth and temperature data and sends it to the NMEA 2000 ® network. Airmar's Smart™ Sensors have embedded microelectronics—the transducer element and signal processor are only ...

Document Part Number: 551506 Revision A (EN) 03/2014. temposonics.com. UNITED STATES. Temposonics, LLC Phone: +1 919 677-0100 E-Mail: info.us@temposonics.com

28 J6 33 34 31 32 J7 21 22 19 20 J8 25 26 23 24 J9 11 12 9 10 J10 15 16 13 14 J11 3 4 1 2 J12 7 8 5 6 Note: nn Designates pin number on 56-pin connector Figure 2. 428 Schematic Diagram. Section 042–800–201 4 5. INSTALLER CONNECTIONS When the 428 module is installed in a type 400 mounting assembly, it makes electrical connection to the ...

pcb.com | 1 800 828 8840 USE OF MODEL 378C20. Model 378C20 is a 1/2 in (12 mm) prepolarized random incidence . response microphone and preamplifier combination.

0.9 mm buffer 5.8 mm outer diameter 0.9 mm buffer outer sheath aramid yarn (strength members) aramid yarn (strength members) MM 100/140μm MM 50/125μm MM 62.5/125μm SM 9/125μm Advantages: • Most common type of connection: rugged, cost-effective • Typically low (0.3dB) insertion loss • Generally less sensitive to liquid contaminates ...

4U6VT360X06F xys4 REV121721NA ACROSS THE WORLD. AROUND THE CORNER. www.amphenol-antennas.com 1 of 11 Quoted performance parameters are provided to offer typical, peak or range values only and may vary as a result of normal testing, manufacturing and operational conditions.

TPC Wire

Magnetic Sensitivity 40 µg/gauss 3.9 (m/s²)/Tesla [2] Electrical Excitation Voltage 5 to 32 VDC 5 to 32 VDC Current Consumption ≤ 15 mA ≤ 15 mA Output Impedance ≤ 120 Ohm ≤ 120 Ohm Offset Voltage(0 g) ± 20 mVDC ± 20 mVDC [6] Common Mode Voltage(+/- 0.1 VDC) 1.65 VDC 1.65 VDC

We would like to show you a description here but the site won’t allow us.

Temposonics Linear Position Sensors & Liquid Level Transmitters

Charles Guy Wire Markers Long-Lasting, Highly Visible Identification for Down Guy Wires and Cable Installations Charles Guy Wire Markers greatly improve safety by providing high

Thru-Hull Triducer® Multisensor spares kit. Fits: B744VC, B744VLC (small cap, no clevis pin) Contains: 1 paddlewheel and shaft, 4 O-rings, 1 valve assembly, 2 pull rings

Azimuth Beamwidth (3 dB) degrees 95.9° ± 18.6° 73.3° ± 23.4° Elevation Beamwidth (3 dB) degrees 83.7° ± 11.7° 75.5° ± 14.9° Electrical Downtilt degrees (w) 0° Impedance Ohms 50Ω VSWR --- ≤ 1.5:1 Passive Intermodulation 3rd Order for 2x20 W Carriers dBc < -153 Upper Sidelobe Suppression dB N/A Isolation Intraband dB > 25 ...

NovaSensor PT1907 Pressure and Temperature Sensor Die